IMAGERUNNER 3025 FUSER CLEANING ROLLER

The built-in system of your Canon imageRUNNER 3025 is constantly monitoring the status of all installed consumables, and it will display an appropriate warning message when your attention is required. You should install a new staple cartridge, if ‘’The stapler unit is out of staples’’ or ‘’The saddle stitcher is out of staples’’ appears on the control display. The installations of a new staple cartridge in a Finisher-S1/Puncher Unit-R1, Optional Saddle Finisher-AE2, Optional Finisher-AE1, and Optional Finisher-AE2, are included below.

Finisher-S1/Puncher Unit-R1

You must open the front cover of the finisher, and then move the finisher to the left by lifting and pulling its handle. After that, you must grasp the green tab of the staple case and pull it upwards to remove the staple case from the finisher. Now, you must press the area labeled ‘’PUSH’’ and pull the empty staple cartridge out of the staple case. Next, you must insert the new staple cartridge into the staple case until it clicks into place, and then detach the protective seal from the new staples. Once the new staple cartridge is inserted, you must slide the staple case back into the finisher, and then return the finisher to its original position. Finally, you must close the front cover of the finisher.

Optional Saddle Finisher-AE2 and Optional Finisher-AE1

In the first step, you must open the cover of the finisher by grasping its handle and pulling gently towards you. Then, you must remove the staple case from the finisher by pulling its green tab out. Now, you must unlock the empty staple cartridge by pushing the labeled area on the staple case, and then pull the used staple cartridge out of the staple case. After that, you must insert the new staple cartridge into the staple case, and then remove the protective seal. In the next step, you must insert the staple case back into the finisher, and then finalize the replacement procedure by closing the front cover of the finisher.