KM-C3232E OEM TONER CARTRIDGES SET

When a paper jam occurs it is important to not reuse paper cleared from a jam. Furthermore if the paper was ripped when removing it, make sure that all loose scraps of paper have been removed.

The first step to resolving a paper jam in Cassette 1 is to open the left cover. Then remove the jammed paper. Be careful not to tear the paper. If any paper has been torn make sure to remove it. Next open duplex unit A1. Then remove any jammed paper in duplex unit A1. The next step is to pull out cassette 1. It is import to remove any paper jammed in this location. Then you want to be careful when pushing cassette 1 back in. Make sure the A1 is correctly returned to its original position. Finally close the left cover carefully.

One common printer error message that you may come across when owning the KYOCERA KM-C3232 is Load Paper ## size (##). If you get this message you should first check, whether the print data feed is the same as the paper size. Next change the size or type of paper. In order to alter the paper source, you must select paper source from the touch panel and press [GO]. To print using the correct sized paper, press the Printer key and press [GO]. The print job can be canceled by pressing the Printer key and [Cancel].

Another error that you may experience with your KYOCERA KM-C3232 is Option interface error Code: ##. If this error occurs check to see whether the installed option interface slot is correct. In the event that it is not in the correct slot then switch the main power switch to off and install it correctly.

A message that says Print overrun Press GO is the result of not having enough memory. To alleviate this error press the Printer key to change to printer mode. After that you need to press [GO] to print. If your printer has been configured for Auto Continue, printing will continue automatically after a few seconds. Then Page Protect will be set to [On].

The error Memory overflow Press GO will occur when printing due to a lack of memory. Users should press the printer key in order to switch to printer mode. Then press [GO] to continue printing. If you have RAM Disk enabled, it is best to decrease the RAM disk size. In the event that this error often occurs you need to add memory to your printer.

Solving a Warning image adapt error is very straight forward. This error is caused by not having enough memory. To alleviate this problem simply add memory to your printer or alter the print resolution.