KYOCERA MITA KM-1810 TONER CARTRIDGE

Your KYOCERA MITA KM-1810 is equipped with a built-in system for a constant toner cartridge monitoring. The system will turn on the [Add Toner] LED indicator, once it detects that the toner level is under the normal working minimum. Please note that the [Add Toner] LED illustrates six black dots in pyramidal order with an arrow pointing toward the dots, and it will be blinking, when the toner level is low. You should replace the nearly empty toner cartridge soon after the initial appearance of the advance notification signal. Otherwise, the remaining toner will be completely consumed very soon, which will lead to the disabling of all print operations. This non-operational printer mode will be also indicated, and you will see the following message ''Replace waste toner tank at the time of toner container exchange surely, and do charge wire cleaning.''. Please note that the described above error message will be printed by the built-in system, immediately after an exhausted toner cartridge has been detected. Additionally, the [Add Toner] LED will be continuously lit. The only available action, in order to be restored the full/normal functionality of your KYOCERA MITA KM-1810, is an installation of a new toner cartridge and a new waste toner container. The complete replacement procedure is included below.

Initially, you must open the front cover of your KYOCERA MITA KM-1810 laser printer. Then, you must remove the waste toner container by carefully pulling it towards you. Please note that you should use the included (to the exhausted waste toner container) tape to seal the exhausted waste toner container, in order to be avoided waste toner spillages. In the next step of the replacement procedure, you must unlock the exhausted toner cartridge by gently sliding it to the left side of the printer, and then remove the exhausted consumable component by pulling it straight towards you. After that, you must clean the primary corona wire of the installed drum unit by pulling the cleaning shaft (located on the top-right corner of the waste toner container slot) towards you, and then push the cleaning shaft back to its original position. Please note that you should move the cleaning shaft several times, in order the primary corona wire of the installed drum unit to be optimally cleaned, and resp. to be avoided future print quality issues. Now, you must unpack the new toner cartridge and the new waste toner container, and then loosen and evenly distribute the toner by shaking the new toner cartridge 8-10 times horizontally. Once the new toner cartridge is prepared, you must insert it into the slot, and then lock the new component into place by gently sliding it to the right side of the laser printer. In the next step, you must install the new waste toner container into the printer, but please make sure that it is completely inserted into the slot. Finally, you must close the front cover of your KYOCERA MITA KM-1810, and wait for the automatic toner replenishment procedure to be executed (approx. 3 minutes).