LANIER LD116 TONER CARTRIDGE

Initially, you must make sure that the Lanier LD116 Laser Copier is switched off, and then unplug the power cord. After that, you must open the front door, and then remove the toner cartridge holder by pulling it towards you while pressing the upper release lever. Now, you must open the right door of the copier, and then remove the imaging unit. In the next step, you must detach the upper part of the imaging unit from the lower part by removing the five fixing screws, and then discharge the used developer. Once the used developer is discharged, you must open the bag containing the new developer, and then pour the new developer equally into the openings of the lower part of the imaging unit. Finally, you must reassemble the imaging unit, and then reinstall it.

In the first step of the replacement procedure, you must switch the Lanier LD116 Laser Copier off, and then unplug the power cord. After that, you must open the front door of the copier, and then remove the mounting screw from the front right cover. Now, you must detach the front right cover from the main unit, and then open the right door. In the next step, you must remove the screws securing the exhausted fuser assembly unit to the main frame, and then unplug the four fuser connectors. Finally, you must pull the exhausted fuser assembly unit out of the Lanier LD116 Laser Copier, and then install the replacement component by executing the current procedure in reverse order.

Initially, you must switch the Lanier LD116 Laser Copier off, unplug the power cord, and then open the right door. Next, you must lift the used transfer roller out of the copier, and then insert the new transfer roller into place. After that, you must remove the two mounting screws from the installed fuser assembly unit, and then unplug the four fuser connectors. Now, you must remove the fuser assembly unit from the copier, detach the hot roller section from the pressure roller section, and then detach the fusing entrance guide by removing the two screws. In the next step of the replacement procedure, you must remove the springs, the pressure arms, and the bushings from the pressure roller section, and then remove the used pressure roller. Once the pressure roller is removed, you must remove the used cleaning roller from the pressure roller section, and then install the new cleaning roller, bushings, pressure arms, springs, and pressure roller. Next, you must remove the hot roller guard, the metal holders, and the hot roller stripper pawls from the hot roller section, and then remove the used hot roller. After that, you must install the new hot roller and the remaining components of the maintenance kit, and then reassemble the fuser assembly unit. Finally, you must reinstall the fuser assembly unit, and then close covers of the Lanier LD116 Laser Copier.