CANON IMAGERUNNER 3300 DECK SEPARATION ROLLER

You should replace the installed staple cartridge, once the following warning message ''Load staples'' has been displayed on the lower-left corner of the control LCD of your laser copier. The staple cartridge replacement procedure for Canon imageRUNNER 3300 equipped with a Saddle Finisher-G1/Puncher Unit-K1 is included below.

Initially, you must open the front cover of the ''G1'' finisher by pulling its right side towards you. Then, you must remove the stapler unit by pulling it carefully out of the finisher. Now, you must detach the staple case from the stapler unit by pulling it upwards, and then towards you. Once the staple case is detached, you must push its marked with <PUSH> area and remove the empty staple cartridge by pulling it upwards. After that, you must insert the new staple cartridge into the staple case, and then pull the fixing seal out of the new staple cartridge. In the next step of the replacement procedure, you must reinstall the staple case into the stapler unit, and then insert the stapler unit into the finisher. Finally, you must close the front cover of the ''G1'' finisher and test your Canon imageRUNNER 3300.