XEROX WORKCENTRE PE120 TONER CARTRIDGE

Replacing a worn out toner cartridge for the Xerox WorkCentre PE120 is simple and straightforward. The machine itself will alert users when the cartridge is out of toner with a TONER EMPTY message displayed on the LCD. Once this message appears, the printer will no longer function until a new cartridge is installed.

To replace the cartridge, open the front door by grabbing the small handle located on the front of the machine and swinging the door downward. Push DOWN on the cartridge’s handle and then pull it straight out of the machine. Old cartridges should be recycled and stored in a plastic bag to prevent them from leaking toner and potentially causing stains.

Unpack a new cartridge only immediately before it is to be installed. To prep a new cartridge for installation, shake it thoroughly in every direction to distribute the interior toner. If toner from the old or new cartridge gets onto clothing, wash it with COLD water as warm water will cause a permanent stain.

Never make contact with the underside of the cartridge but instead always handle it by its sides or handle. To insider the cartridge, line its guide tabs up with the rails inside the printer and slowly insert it into the device. If installed properly, the cartridge will lock into position. At this point the door to the printer can be closed and a test page should be printed to ensure that the installation was successful.

Copies and scans of single page and three dimensional input material can be executed by using the Xerox WorkCentre PE120’s flip top cover and document glass. To make a copy, first lift the cover and expose the document glass. Place the input material FACE DOWN onto the glass, being sure to line it up with the guide in the top left corner of the scanner.

No documents can be in the ADF when using the scan glass. If there is input material in the ADF when attempting a single page copy, the ADF will take priority over the glass. When possible, do not leave the cover to the glass open while making a copy, but do not force the cover closed when copying a three dimensional object as this could crack the document glass. As a rule of thumb, only input material 30 mm or thinner should have the document cover closed completely onto it.

Once the copy material is in place, close the cover to the glass. At this point, copy settings can be fully customized by using the dedicated controls. To clear all custom settings, press the STOP/CLEAR button. When you have set the settings properly, press the START button to begin copying.

Similarly to the scanner glass, copies can be made on the Xerox WorkCentre PE120 via its built in automatic document feeder. When loading the document feeder, always load input material FACE UP and in quantities of no more than 50 SHEETS.

Make sure that the document guides on the sides of the input tray are fitted against the input material. If they are not, simply adjust them so that they touch the sides of the paper.

At this point, copy settings can be adjusted by using the dedicated control panel and LCD screen. Once settings are properly set, press the START button to begin the copy process.