Xerox Phaser 4510 Fuser Maintenance Kit (OEM) 200,000 Pages
What is a Fuser Maintenance Kit? If your laser printer is giving you an error message like "Perform Printer Maintenance" or "Replace the Fuser Kit", a Fuser Maintenance Kit is what you need. These kits vary, but most will contain a fuser assembly unit, transfer & pick-up rollers, paper feed & separation rollers, air filters, and other components for your laser printer.
When do I Replace a Fuser Maintenance Kit in the Xerox Phaser 4510 Laser Printer?
The Fuser Maintenance Kit installed in your Xerox Phaser 4510 Laser Printer has a certain printing resource, which will be consumed eventually. Once the Fuser Maintenance Kit is near the end of its useful life, you will see the following message ‘’Maintenance Kit is Near End Of Life’’ on the control display of your Phaser 4510, and you must replace the exhausted Fuser Maintenance Kit with a new one. You should also replace the Fuser Maintenance Kit, if the following printing quality issues are reappearing: light prints, blank prints, black prints, vertical line deletions, horizontal line deletions, vertical dark streaks, horizontal dark streaks, dark spots/marks, blurred prints, spot deletions. Please also note that all printing operations will be suspended, when the Fuser Maintenance Kit runs completely out of printing resource.
How to Install a Fuser Maintenance Kit in the Xerox Phaser 4510 Laser Printer
Before starting with the Fuser Maintenance Kit replacement, you must turn off the printer by pushing its power switch/button to position ‘’O’’ and unplug its power cable from the AC outlet. Once the printer has been unplugged from the electrical circuit, you must wait for at least 30 minutes before proceeding with the below removal procedure.
Initially, you must open the Fuser Maintenance Kit door located on the backside of your Xerox Phaser 4510 Laser Printer by pulling up its lock release lever. Then, you must locate the fuser maintenance kit and push down its lock release lever. After that, you must remove the exhausted fuser maintenance kit from the printer by pulling it towards you. Once the exhausted/old fuser maintenance kit is out, you must unpack the new one and slowly insert it into the printer` slot. Now, you must lock the new fuser maintenance kit into place by pulling its lock release lever upwards. Finally, you can close the fuser maintenance kit`s door and test your Xerox Phaser 4510 Laser Printer.