KONICA MINOLTA BIZHUB C353 BLACK DRUM

One of the messages listed below will be displayed when the time to replace the drum unit is reached.

[Please replace following units <> Imaging Unit X]

[Imaging Unit needs to be replaced. Replace it following the instructions]

Initially, you must turn off the Konica Minolta BizHub C353 Laser Printer by pressing the sub power switch, and then open the front door. After that, you must set the main power switch to [0], and then unlock the exhausted drum unit by pressing down its release. Once the exhausted drum unit is unlocked, you must remove it by pulling it towards you, and then take the new drum unit out of the transport box. Please do not hold the top part of the new drum unit. Now, you must remove the packing tape and the protective material, and then take the new drum unit out of the black protective bag. In the next step of the replacement procedure, you must gently shake the new drum unit 4-5 times from side to side horizontally, and then peel off the protective tape. After that, you must remove the two protective covers, and then insert the new drum unit into the laser printer, making sure that the mark on the new component is aligned with the mark of the slot. Once the new drum unit is fully inserted, you must remove the protective sheet by pulling its handle towards you, and then set the main power switch to [I] position. Finally, you must close the front door of your Konica Minolta BizHub C353 Laser Printer.