HP LASERJET 1200 JUMBO YIELD TONER CARTRIDGE

You should replace the toner cartridge installed in your HP LaserJet 1200 if any of the listed indications persists.

 

·         Faded printouts

 

·         Dropouts

 

·         Vertical lines

 

·         Background shading

 

·         Toner smear

 

·         Loose toner

 

·         Repetitive image defects

In the first step of the replacement procedure, you must open the door of the toner cartridge compartment, and then remove the exhausted toner cartridge. After that, you must unpack the new toner cartridge, and then shake it several times from side to side. Now, you must remove the protective tape from the new toner cartridge, and then insert the new component into place. Finally, you must close the cover of the toner cartridge compartment.

Initially, you must switch the HP LaserJet 1200 off, and then unplug the power cord. After that, you must remove the left and back covers, and then remove the right and top covers. Now, you must remove the three screws from the right fuser plate, and then remove the bracket. In the next step of the replacement procedure, you must remove the three screws from the left fuser plate, and then remove the left bracket. Once the left bracket is removed, you must remove the left and right fixing screws, and then unplug the cable connector of the exhausted fuser unit. Next, you must unplug the five connectors from the ECU, and then unplug the spade connector. After that, you must remove the screw from the paper delivery sensor, and then remove the paper delivery sensor. Finally, you must remove the exhausted fuser unit from the HP LaserJet 1200, and then install the replacement component by executing the current procedure in reverse order.

In the first step of the replacement procedure, you must remove the left, back, right, and top covers. After that, you must unplug the five connectors from the ECU, and then unwind all cable connections. In the next step of the replacement procedure, you must remove the two screws that secure the exhausted fan assembly to the main unit, and then remove the exhausted component from the HP LaserJet 1200. Finally, you must unpack the new fan assembly, and then install it by executing the current procedure in reverse order.