HP LASERJET 1018 TONER CARTRIDGE - HIGH YIELD

In the initial step of the replacement procedure, you must switch the HP LaserJet 1018 off, and then unplug the power cord. After that, you must remove the right cover, and then remove the left cover. Now, you must remove the top cover assembly, and then remove the front cover. In the next step of the replacement procedure, you must disconnect the six cables from the power assembly, and then remove the four fixing screws. Once you have removed the screws, you must disconnect the high voltage wire, remove the two rear fixing screws, and then remove the exhausted engine power assembly. Finally, you must unpack the new engine power assembly, and then install it by executing the current procedure in reverse order.

You should replace the fuser unit installed in your HP LaserJet 1018 if any of the listed problems persists.

 

·         Black vertical lines

 

·         Toner smear

 

·         Loose toner

 

·         Repetitive vertical image defects

In the first step of the replacement procedure, you must switch the HP LaserJet 1018 off, and then unplug the power cord. After that, you must remove the right cover, and then remove the left cover. Now, you must remove the top cover assembly, and then disconnect the cable from the engine power assembly. In the next step of the replacement procedure, you must disconnect the high voltage wire, and then detach the wire harness from the retainers. Once you have released the wire harness, you must remove the three fixing screws, and then remove the exhausted fuser unit. Finally, you must unpack the new fuser unit, and then install it by executing the current procedure in reverse order.

You should replace the paper pickup assembly installed in your HP LaserJet 1018 if you notice image defects appearing at intervals of 2.17 inches.

Initially, you must switch the HP LaserJet 1018 off, and then unplug the power cord. After that, you must remove the right cover, and then remove the left cover. Now, you must remove the top cover assembly, and then remove the transfer roller. In the next step of the replacement procedure, you must remove the fuser unit, and then unplug the solenoid wire from the formatter. Once you have unplugged the wire, you must remove the six screws securing the exhausted paper pickup assembly, and then remove the exhausted component. Finally, you unpack the new paper pickup assembly, and then install it by executing the current procedure in reverse order.

In the initial step of the replacement procedure, you must switch your HP LaserJet 1018 off, and then unplug the power cord. After that, you must remove the right cover, and then remove the left cover. Now, you must remove the top cover assembly, and then remove the front cover. In the next step of the replacement procedure, you must unplug the FFC from the formatter, and then unplug the FFC from the engine power assembly. Once you have disconnected the two FFCs, you must remove the four fixing screws, and then remove the ECU cover. Next, you must release the plastic wire-retainer tab, and then detach the retainer from the main frame. After that, you must unplug the FFC and the connector from the step motor, and then remove the two screws securing the exhausted ECU. Finally, you must remove the exhausted ECU, and then install the replacement component by executing the current procedure in reverse order.

In the first step of the replacement procedure, you must switch the HP LaserJet 1018 off, and then unplug the power cord. After that, you must remove the right cover, and then remove the left cover. Now, you must remove the top cover assembly, and then remove the front cover. In the next step of the replacement procedure, you must remove the engine control unit assembly, and then remove the four screws securing the exhausted laser scanner assembly. Finally, you must remove the exhausted laser scanner assembly, and then install the replacement component by executing the current procedure in reverse order.