OKIDATA PACEMARK 4410 OEM RIBBON CARTRIDGE (CHARACTER YIELD)

You must start the ribbon cartridge replacement procedure by turning off your dot matrix printer, and then open the top/printhead access cover, but please be aware that the printhead will be hot. After that, you must move the printhead to the marked ribbon loading position, and then detach the ribbon from the printhead. Now, you must remove the exhausted ribbon cartridge by carefully pulling it towards you. In the next step of the replacement procedure, you must unpack the new ribbon cartridge, and then swing out the ribbon arms until they snap into place. Then, you must locate the plastic ribbon restraint (look at the right end of the new cartridge) and push it in. After that, you must remove the red shipping restraint, and then insert the new ribbon cartridge into the printer, but make sure that the ribbon arms are located over the metal tabs of the slot. Once the new ribbon cartridge is inserted, you must attach the ribbon to the printhead, but be careful not to twist it, and then tighten the ribbon by gently turning the blue knob of the new cartridge in a clockwise direction. Finally, you must close the top/printhead access cover of your OKIDATA PaceMark 4410.