EPSON WORKFORCE 30 MAGENTA OEM INK CARTRIDGE

You can check the status of the ink cartridges by using the Epson Information Center. You should replace the installed ink cartridges when the [Ink] indicator remains on.

Initially, you must make sure that the Epson WorkForce 30 All-in-One Printer is switched on, and then open the top cover. After that, you must press the [Ink] button, wait until the printhead stops moving, and then press the [Ink] button again. Once the printhead stops moving, you must open its top cover, and then remove the exhausted ink cartridge by pulling it up while squeezing the release tab. Now, you must shake the new ink cartridge several times from side to side, and then remove the plastic bag and the yellow protective tape from the cartridge. Please do not touch the green chip of the new ink cartridge. In the next step of the replacement procedure, you must insert the new ink cartridge into the corresponding slot, and then push it down to lock it into place. Once the new ink cartridge is inserted, you must close the printhead cover, and then close the top cover of your Epson WorkForce 30 All-in-One Printer. Finally, you must initialize the new ink cartridge by pressing the [Ink Button].