CYAN OEM TONER CARTRIDGE for DELL 3130CN LASER PRINTER

When the Dell 2135CN indicates that it is time for a toner cartridge change, have a new cartridge handy and begin the replacement procedure by pressing the side button and opening the front cover of the unit. The old print cartridge will be seen in the top cartridge slot behind the door. This cartridge can be pulled free and must be disposed of properly, preferably by recycling.

When installing a new cartridge, begin by holding the cartridge by both sides and shaking it around about five times in a side to side motion to loosen the toner inside. Some orange/yellow tape will be seen hanging from the cartridge and must now be pulled completely out of the cartridge.

It is now time to remove the black protective cover from the cartridge, but once this cover Is removed the cartridge must be inserted immediately into the printer or the life of the toner will be shortened due to light exposure.

Install the cartridge by grasping the handles on either side of it, being careful to never touch the exposed areas of the cartridge, and sliding it into the correct color slot. Be sure that the cartridge is seated firmly into position.

NOTE: From top to bottom the order of colors in the Dell 2135CN is Black, Cyan, Magenta, and Yellow.

If other colors of toner cartridges need to be installed, simply repeat these steps to complete the procedure, but never keep the front door of the unit open for more than five minutes as this will cause light damage to existing cartridges.

If desired, the instruction sheet can be peeled off the top of the printer once the procedure has been learned. When the cartridges are all installed correctly, close the cover to the printer and print a test page.

An optional duplexer is available for the Dell 2135CN that can be installed manually by a user without a technician. To install the duplexer, the front cover of the machine must be opened but the installation procedure should be completed within five minutes or else the toner inside could receive damage from light.

Be sure that the printer is turned off before attempting any installation procedure and remove all the packaging from the duplexer. Press the side button of the Dell 2135CN to release the front cover which must then be opened. With the front cover open, it is always important to be careful not to scratch the exposed belt unit.

Release the belt unit by pulling up on its lock lever and rotate it upwards. Locate the connector cap found under the belt unit and remove it completely. This will create a chasm for the duplexer to fit into. Point the connector of the duplexer towards this grove and push the unit down into it. Locking tabs on the sides should snap into place, but test the duplexer as well to make sure it is secure. If it is in proper position, the best unit can be dropped closed and the entire front cover of the printer can be as well.

Turn the printer back on and print a PRINTER SETTINGS page which will indicate on it if the duplexer has been installed correctly.