C8800 CYAN OEM TONER CARTRIDGE

The precise monitoring system of your OKIDATA C8800 is constantly receiving information from special built-in (in each consumable component) sensors about the current condition of the installed toner cartridges. Once the built-in system detects that one or several of the installed toner cartridges are near the end of its/their useful life, it will display one or several of the included below warning messages.

''ORDER TONER 410: YELLOW''
''ORDER TONER 411: MAGENTA''
''ORDER TONER 412: CYAN''
''ORDER TONER 413: BLACK'' – Please note that the letter ''K'' is used for an indication of the installed Black toner cartridge.

You should install a new toner cartridge/cartridges of the indicated color, soon after the initial appearance of the warning message/messages. Otherwise, the remaining toner will be consumed very soon, which will lead to a non-operational printer's mode, and resp. to the complete disabling of all print operations. The non-operational mode will be also indicated by the built-in monitoring system, and you will see one or several of the error messages listed below.

''REPLACE TONER 410: YELLOW''
''REPLACE TONER 411: MAGENTA''
''REPLACE TONER 412: CYAN''
''REPLACE TONER 413: BLACK''

The only available action, after the appearance of any of the listed above error messages, is an installation/installations of a new toner cartridge/cartridges of the indicated color/colors. Please note that you will have to install a new toner cartridge/cartridges, if any of the listed below error messages is appearing on the control display, even after a correct installation of the indicated toner cartridge.

''TONER SENSOR ERROR CYAN''
''TONER SENSOR ERROR YELLOW''
''TONER SENSOR ERROR MAGENTA''
''TONER SENSOR ERROR BLACK''

Initially, you must open the top cover of your OKIDATA C8800 by pressing its release button. Please be aware that the indicated with a warning sign fuser unit will be very hot, if you have recently used your printer. In the next step of the replacement procedure, you must locate the exhausted toner cartridge, and then pull its colored lock release lever towards you, in order to unlock it from its corresponding slot/drum unit. Please note that the correct toner cartridge installation order is as follows (from the rear side of the printer): Cyan, Magenta, Yellow, and Black. After that, you must remove the exhausted toner cartridge from the printer by lifting its right end first, then sliding the cartridge to the right and lifting it out of the compartment. Now, you must take the new toner cartridge out of the protective packaging, and then shake it 8-10 times horizontally, in order the toner to be loosened and evenly distributed inside the cartridge. Then, you must remove the protective tape from the shutter of the new toner cartridge, but please be careful not to touch the lock release lever of the cartridge. Once the new toner cartridge is prepared for installation, you must insert its left side into the slot, and then push the right end of the new cartridge down until it fits firmly into the drum unit below. In the next step of the replacement procedure, you must secure the new toner cartridge by pushing its colored lock release lever towards the rear side of the printer, and then clean the LED lens (located on the top cover) with the included with the toner cartridge cleaner. Finally, you must close the top cover, and then test your OKIDATA C8800 laser printer.