E-STUDIO 2500C YELLOW TONER CARTRIDGE

Toshiba e-Studio 2500c Laser Printer is equipped with Toner Cartridge monitoring system, which will signal before a certain toner cartridge run completely out of toner. When the toner level in any of the 4 cartridges is too low, a blinking symbol will appear on your printer`s display. After the blinking symbol, a specific message will be displayed, which will inform you about all exhausted cartridges. All possible messages are listed below:

``Install new Black toner cartridge``
``Install new Yellow toner cartridge``
``Install new Magenta toner cartridge``
``Install new Cyan toner cartridge``

If more than 1 toner cartridge is exhausted, then one of the below messages will appear, where the used capital letters are the first letters of each exhausted toner cartridge:

``Install new Y M toner cartridges``
``Install new Y C toner  cartridges``
``Install new Y B toner cartridges``
``Install new B M toner cartridges``
``Install new B C toner cartridges``
``Install new M C toner cartridges``

In all of the above examples, you must change your Toshiba e-Studio 2500c Toner Cartridge/Cartridges

The first step is to navigate to [user]-[function]-[general] in your printer control panel, and then select the [replace toner cartridge].
In order to replace the exhausted toner cartridge/cartridges, you must open your printer`s front cover and locate the exhausted cartridges. To remove a toner cartridge, you must grab the upper side of the toner cartridge and slowly pull it towards you. Please note, that the cartridge is long, and it would be safer if you support it with your other hand, when the cartridge is halfway out of the printer. Now, it is time to install your new cartridge, but before that, you should strongly shake the new cartridge to loosen the toner inside. Please note that the new toner cartridge should be positioned with the label surface down, while you are shaking it. The next step is to remove the cartridge`s seal in the direction displayed by the arrow. Now, you have to simply push the new toner cartridge on the same place, where the exhausted cartridge/cartridges was/were located, until it stops into position. The final step of the Toshiba E-Studio 2500c toner cartridge replacement is to close the front cover, and then you can start using your printer with the newly installed toner cartridge/cartridges.