E-STUDIO 3510C OEM STAPLE CARTRIDGES

Depending on the installed finisher, your Toshiba e-Studio 3510c could warn you for exhausted Staple Cartridges at some point. The message that will appear on you control display will state the following - ``Check staple cartridges``. This message is displayed in the upper left corner of your e-Studio 3510c`s display, and usually, you should replace the old staple cartridges in this situation.

There are two different staple replacement procedures, according to the exact type of the installed finisher.

Below is described the replacement of the staple cartridges in Toshiba e-Studio 3510c with installed MJ-1101 Finisher.

First, you must open the front cover of your MJ-1101 Finisher and take off the staple cartridges by pulling the staple cartridge towards you, while pushing down the cartridge`s lever. Then, you should simply put in place the new staple cartridges until it is fixed with a click in your Toshiba laser printer. Finally, you must close the front cover and check, if the ``Check staple cartridge`` message is still appearing. If the message is still there, simply repeat the install procedure.

Below is described the replacement of the staple cartridges in Toshiba e-Studio 3510c with installed MJ-1030 Finisher.

First, you must open the front cover of your MJ-1030 Finisher and take off the staple cartridges by pulling the staple cartridge towards you, while pushing down the cartridge`s lever. Now, you must take out the empty staple case and remove the bundling seal from the staples. Next, you must put in a new staple case (not required, if you change the entire staple cartridge) into the cartridge, and then you can insert the staple cartridge into the stapler. Finally, you must close the front cover and check, if the ``Check staple cartridge`` message is still appearing. If the message is still there, you should simply repeat the above install procedure.