BROTHER DCP-7057 TONER CARTRIDGE

The Brother DCP-7057 will display one of the listed messages if the installed toner cartridge needs replacing.

· [TONER LOW]

· [TONER ENDED]

· [REPLACE TONER]

· [CARTRIDGE ERROR]

· [NO TONER]

Initially, you must switch your Brother DCP-7057 on, and then wait at least ten minutes. After that, you must remove the drum unit and toner cartridge assembly by sliding it slowly in direction towards you, and then release the lock of the exhausted toner cartridge by pressing the green lever that is located on the left side of the drum unit. Now, you must remove the exhausted toner cartridge from the drum unit, and then remove the packing material from the new toner cartridge. In the next step of the replacement procedure, you must shake the new toner cartridge several times from side to side horizontally, and then detach the protective plastic cover from the toner roller of the new component. Once the protective plastic cover is removed, you must insert the new toner cartridge into the drum unit, and then ensure that the new component is locked into place. Next, you must clean the primary corona wire of the drum unit by sliding the green tab (located on the top side of the drum unit) 2-3 times from left to right and right to left, and then return the tab to its original position. Finally, you must insert the drum unit and toner cartridge assembly into the Brother DCP-7057, and then close the front cover.