XEROX PHASER 6115 YELLOW TONER CARTRIDGE

The toner cartridge carousel of your Xerox Phaser 6115 Color Laser Printer contains four toner cartridges: Cyan, Magenta, Yellow, and Black. You can check the percentage of remaining toner by pressing the [Display] button once. Please note that you can obtain detailed information about all installed consumables by printing a configuration page.
An installed toner cartridge must be replaced if it is exhausted, incompatible, damaged, or defective. All system notifications and print quality problems, which indicate toner cartridge related abnormalities, are listed below.

Blank printouts or blank spots on the printed page; solid black or color printouts; image is too dark; image is blurred; background is stained; residual images; image defects – The most common cause for these print quality problems is a damaged or defective toner cartridge(s). Therefore, you should remove the installed toner cartridges from the Xerox Phaser 6115 Color Laser Printer, and check them for damages/defects. All damaged/defective toner cartridges must be replaced.

Image density is too low; print density is uneven – An indication for a low toner level. All nearly empty toner cartridges must be replaced.

The message [X TONER EMPTY], [TONER LIFE END <> CHANGE X TONER], or [X TONER EMPTY <> CHANGE X TONER] is displayed – The indicated toner cartridge is empty. You must install a new [X] toner cartridge.

The message [X TONER INCORRECT] is displayed – The indicated toner cartridge cannot be used in your Xerox Phaser 6115 Color Laser Printer. You must install a new, compatible [X] toner cartridge.

The message [X TONER LOW] is displayed – The toner remaining in the indicated cartridge will be consumed within 200 A4 pages at 5% coverage. You must make sure that you have a new toner cartridge of the specified color in stock.

The message [X TONER NOT INSTALLED] is displayed – The Xerox Phaser 6115 Color Laser Printer does not detect the specified toner cartridge. Please make sure that the specified toner cartridge is installed properly. You will have to install a new [X] toner cartridge if the problem persists.

You must start the replacement procedure by pressing the [Rotate Carousel] button. Then, you must close the output tray and lift the scanner unit. After that, you must open the top cover and the front cover of your Xerox Phaser 6115 Color Laser Printer, and then unlock the exhausted toner cartridge by rotating it towards the scanner unit. Now, you must remove the exhausted toner cartridge from the machine, and then shake the new toner cartridge 7-8 times up and down. In the next step of the replacement procedure, you must remove the plastic bag and the protective cover from the new toner cartridge, and then insert the new component firmly into the corresponding slot of the carousel. Once the new toner cartridge is inserted, you must push it down until it clicks, and then close the front cover. Finally, you must close the top cover, and then lower the scanner unit.